User guide

WHEATHEART - GHR & WHR GRAIN AUGERS 3. ASSEMBLY
PTO-SD DRIVE MODEL 3.15. TRANSPORT SADDLE
30641 R1 37
MODEL K1051 & K1550
See Figure 3.26.
1. Slide handle over flat sides of
input shaft.
2. Fasten with 1/2” locknut.
Do not remove or loosen the double
locknut on the input shaft: it is an
important part of the brake system of
the winch.
MODEL K2550
See Figure 3.27.
1. Slide handle over flat
sides of input shaft.
2. Fasten with 1/2”
locknut.
Do not remove or loosen
the locknut on brake side
of winch: it is an important
part of the brake system of
the winch.
3.15. TRANSPORT SADDLE
Install transport saddle for the PTO driveline to auger tube about 3’ above
gearbox assembly. Secure with two 7/16” x 1" bolts and locknuts.
Important: Do not cover decals with gearbox or transport saddle. Replace any decal that is
not clearly visible, available at no charge upon request.
Figure 3.26
Important:
Figure 3.27
Important:
DANGER
Never use a PTO driveline without a rotating
guard in good working order.
Do not exceed maximum recommended
operating length or angularity of PTO
driveline.