Manual

3. ASSEMBLY WHEATHEART - GHR & WHR GRAIN AUGERS
3.9. TRANSPORT UNDERCARRIAGE GRAIN AUGERS SD
26 30662 R1
3.9. TRANSPORT UNDERCARRIAGE
See Figure 3.12.
1. Fasten the lower reach arms to the axle with three 5/8” x 2" bolts and
locknuts on each side.
2. Attach long tubular crossmember to bottom of large frame brackets with 
5/8” x 1-1/2” bolts and locknuts (Figure 3.12).
3. Attach short channel crossmember loosely to small frame brackets with two
5/8” x 2" bolts and locknuts, sandwiching the flat braces (B) between short
crossmember and small frame brackets on each side. Leave this way until
you raise the discharge end.

4. For 61’ and 71’ augers only: Secure the tubing crossbraces to the welded
lugs on the lower reach arms with four 1/2” x 1-1/4” bolts and locknuts, and a
fifth one where the braces cross. Tighten securely.
Figure 3.12
5. Wheel hub assembly:
a. Remove any dirt or paint
from spindle and hub.
b. Thoroughly pack wheel
bearings and cups with a
good grade of bearing
grease.
c. Place large bearing into
hub and carefully tap in
seal.
d. Slip hub onto spindle
and insert small bearing.
Figure 3.13