Manual

3. ASSEMBLY WHEATHEART - GHR & WHR GRAIN AUGERS
3.2. TRACK SHOE & TRACK STOP GRAIN AUGERS SD
18 30662 R1
3. Slide tube sections together and secure.
Make sure to align upper and lower track
ends and then tighten bolts. Secure with
hardware in table below.
Track ends must align to allow track shoe to
smoothly slide over track joint. Misalignment
may cause jamming.
Figure 3.2
3.2. TRACK SHOE & TRACK STOP
1. Slide the roller track shoe onto track with cable attach rod towards auger
intake (Figure 3.3)
2. Attach the angle track stop as shown in Figure 3.4 with four 7/16” x 1-1/4”
bolts and locknuts (see below for correct location, or refer to Figure 3.11).
Details for fasteners
For Flighting Amt For Tubes Amt
5/8” x 4-1/2” GR
8 bolts and
locknuts
2
7/16” x 1-1/4”
bolts and lock-
nuts
12
Figure 3.1
Important: