Owner manual

3. ASSEMBLY WHEATHEART - GHR & WHR GRAIN AUGERS
3.11. UPPER HOUSING LUBRICATION GRAIN AUGERS
26 30661 R2
3.10.1. WINCH HANDLE
This auger may use one of several different winch models. Before installing
handle on the main winch assembly, check the model number stamped on winch
housing and follow the correct set of instructions.
MODEL K2550
1. Slide handle over flat sides of
input shaft.
2. Fasten with 1/2” locknut.
Do not remove or loosen the locknut
on brake side of winch: it is an
important part of the brake system of
the winch.
3.11. UPPER HOUSING LUBRICATION
Fill enclosed upper drive housing with grease.
For continuous use in extreme cold conditions, semi-fluid arctic grease or heavy
oil may be used.
3.12. PLASTIC MANUAL HOLDER
Before beginning installation, ensure that all
winch / auger lift controls are locked in place
and shut down and/or lock out auger.
1. Attach holder to the lower frame arms.
Manual holder must be accessible at all
times, whether frame is up or down.
2. The manual holder cap must face up
(towards the intake end). Attach manual
holder with supplied zip ties. Tighten the zip
ties, securing the holder in place.
Where possible, attach the zip ties above a
frame brace tab to prevent the manual holder
from slipping down the lower frame arms.
CAUTION
Winch handle assembly must follow the
instructions below. Improper assembly will
result in sudden winch failure causing
damage to equipment and/or personal injury.
Figure 3.18
Important:
2200 g 78 oz
LOWER
REACH
ARMS
PLASTIC
ZIP TIES
C
A
P
F
A
C
I
N
G
I
N
T
A
K
E
Figure 3.19
Note: