Owner manual

3. ASSEMBLY WHEATHEART - GHR & WHR GRAIN AUGERS
3.9. TRANSPORT UNDERCARRIAGE GRAIN AUGERS
24 30661 R2
Figure 3.12
5. Fasten upper lift arms to lower reach arms with 3/4" x 2" bolts and locknuts.
Do not over-tighten. Tighten snug only; these bolts act as pivot points.
6. Raise the discharge end of auger with a
front end loader and a strong sling / chain
or block and tackle. The height should be
sufficient to clear undercarriage assembly.
7. Position transport undercarriage beneath tube assembly and attach lower
reach arms (Figure 3.13) to mounting bracket on bottom tube with 3/4" x 2"
bolts and locknuts. Do not over-tighten. Tighten snug only as these bolts act
as pivot points.
WARNING
Do not remove tube support until auger is fully
assembled.
Figure 3.14
Figure 3.13