Owner manual

3. ASSEMBLY WHEATHEART - GHR & WHR GRAIN AUGERS
3.7. DRIVESHAFT SHIELD GRAIN AUGERS
22 30661 R2
3.7. DRIVESHAFT SHIELD
Before installing the driveshaft shields, refer to Table 3.3 for the proper sequence
for your particular auger. Install shields working from the gearbox assembly up to
the discharge end.
To install:
1. Place driveshaft shield
against gearbox and over
chain coupler guard, then
secure with a guard strap and
2 self-tapping screws (Figure
3.6).
2. To install remainder of the
driveshaft shielding, work
from the bottom up. Shields
should overlap at bearing support brackets (Figure 3.9).
Note: When installing driveshaft shielding, refer to step 1 in Table 3.3.
3. Fasten with shield strap and self-tapping screws. Do not tighten until all
shielding is in place.
3.8. DISCHARGE SPOUT
1. Attach discharge spout with two
7/16" x 1-3/4" bolts and locknuts
(Figure 3.10).
Figure 3.9
Table 3.3 Driveshaft Shielding Sequence
STEP
130-41 SD 130-41 EMD
QTY LENGTH QTY LENGTH
1 1 60” (1.52 m) 1 60" (1.52 m)
2 3 42” (1.07 m) 5 48" (1.22 m)
3 5 48” (1.22 m) 1 42” (1.07 m)
4 1 42” (1.07 m) - -
Figure 3.10