Owner manual

WHEATHEART - GHR & WHR GRAIN AUGERS 3. ASSEMBLY
GRAIN AUGERS 3.6. EMD DRIVE
30661 R2 21
Figure 3.8
16. Attach the guard to gearbox assembly by bolting the guard mount bracket to
the short angle with one 3/8" x 3/4" bolt and washer locknut.
17. Secure the other end of guard by bolting the “wide” guard mount angle to the
“narrow” guard mount angle with two 5/16" x 5" bolts and locknuts. Adjust the
width of guard at the motor pulley to suit the pulley diameter.
When using an electric motor:
• The motor and controls should be installed by a qualified electrician in
accordance with all local and national codes.
• Incorporate a magnetic starter to protect the motor.
• The motor must have a manual reset button.
• Locate reset and starter controls so that the operator has full view of the
entire operation.
• Locate main power disconnect switch within reach from ground level to
permit ready access in case of an emergency.
• A main power disconnect switch capable of being locked (in the off posi-
tion only) must be provided.