Instruction Manual

5. OPERATION WHEATHEART MANUFACTURING - TRANSFER AUGER
5.2. DRIVES & LOCKOUTS 8”, 10”, & 13”
28 IM2 R2
5.2. DRIVES & LOCKOUTS
Correct operation of this unit requires pre-inspection of the drive system,
operator knowledge on how to shut down the system, and a general monitoring
of the system during operation.
GAS ENGINE
DRIVE SYSTEM
Before starting the engine, ensure that:
• The gas tank is properly closed.
• The belt release is disengaged.
• The area surrounding auge is properly ventilated.
• Pulley guards are in place and secure.
LOCKOUT
• Shut down and lock out power source.
• remove the spark plug wire or the spark plug.
ELECTRIC MOTOR
DRIVE SYSTEM
Before starting the motor, ensure that:
• The motor is properly grounded.
• All electrical connections/wiring should be performed by a licensed electri-
cian.
• Pulley guards are in place and secure.
LOCKOUT
• The electric motor should be equipped with a main power disconnect switch
capable of being locked in the off position only. The switch should be in the
locked position during shutdown or wherever maintenance is performed on
the auger.
• If no disconnect switch, disconnect power source.
• If reset is required, disconnect all power before resetting motor.
HYDRAULIC MOTOR
DRIVE SYSTEM
Before starting the motor, ensure that:
• Hoses are not leaking and are free of cracks.
• Hose connections are free of dirt and debris.
LOCKOUT
• Shut down power source and disconnect hydraulic hoses from power source.