Owner's manual

WHEATHEART - SA FLEX AUGER 2. SAFETY
71’ - 111’ 2.3. OPERATION SAFETY
30651 R5 9
• Inspect lift cable before using auger. Replace if frayed or damaged. Make
sure it is seated properly in the cable sheaves and that cable clamps are
secure.
• Operate auger on level ground free of debris. If ground is uneven, anchor the
auger to prevent tipping or upending.
• Augers are not insulated. Keep away from electrical lines. Electrocution can
occur without direct contact.
• Support the discharge end and/or anchor the intake end before operating to
prevent upending.
• Do not use auger as a hoist.
• Empty auger before raising or lowering.
• Lower auger at completion of operation or when not in use. Auger could drop
rapidly if the cable breaks or if the hydraulics fail (where applicable).
• Do not operate auger with the service or cleanout doors open or unlatched.
• Do not get on or beneath auger when raising or lowering intake hitch jack, or
when auger is supported by hitch jack.
• Do not operate auger with intake hopper in transport position. This will cause
damage to the u-joint.