Owner's manual
WHEATHEART - SA FLEX AUGER 3. ASSEMBLY
71’ - 111’ 3.16. FLEX AUGER HYDRAULICS
30651 R5 73
5. Continue to run hoses up flex tube and
down flex frame and secure to hose
holders as shown in Figure 3.64. Leave
6” (15.2 cm) between the hose sleeve
and plastic clamps. Assemble hoses
into clamp as on top so that the colors
match the same stacking pattern as
shown in Figure 3.63.
6. Connect outriggers with
hoses (1) and (2) as shown
in Figure 3.61. Refer to Table
3.5 for hose part numbers.
7. Connect hose ends to
outrigger cylinder as shown
in Figure 3.65.
8. Connect other two hoses to
hydraulic winch valve as shown in Figure 3.66.
Connect green end as shown. Yellow end
receives the farmer-supplied pioneer coupler to
connect to the tractor.
Figure 3.64
RED
WHITE
Figure 3.65
RED
WHITE
Figure 3.66
YELLOW