Owner's manual

3. ASSEMBLY WHEATHEART - SA FLEX AUGER
3.13. HYDRAULICS (71’–91’) 71’ - 111’
54 30651 R5
Figure 3.37
11. Place both hoses into retaining brackets welded to side of auger tube and
boot. Bend tops of brackets over slightly to hold hoses in place.
Important: Protect hose ends from dirt.
12. Recheck that bolts on undercarriage, lift cylinders, and cable clamps are
tight, then remove auger tube support.
3.13. HYDRAULICS (71’–91’)
3.13.1. CYLINDER INSTALLATION
Note: See Table 3.3 for the appropriate cylinders.
1. The transport brace (item 34 from Figure 3.24) must be installed and
supporting the frame.
2. Position the cylinders (1) on the cylinder lugs (2). The rod end of the
cylinders must be attached to the lower cylinder mount so that the rod
extends towards the intake (Figure 3.38).
Note: The ports need to be facing each other, see Figure 3.39.
BACK ARM
BRACKET