Owner's manual

WHEATHEART - SA FLEX AUGER 3. ASSEMBLY
71’ - 111’ 3.7. TRUSS 71’–91’
30651 R5 33
4. Pull the long truss cable (2):
over the cable bridges (7)
around the cable return bracket (8)
back over the cable bridges (7)
back to the cable anchor racket (5)
5. Pull the short truss cable (3):
over the middle cable bridge (7)
around the cable return bracket (8)
back over the middle cable bridge (7)
back to the cable anchor bracket (5)
Important: The long truss cable (2) must be installed on the outside of the middle bridge (7).
6. Use loosely attached 5/16” cable clamps to hold the cable in place — 2 cable
clamps per cable bridge and two clamps on the cable return bracket.
Note: Do not tighten the cable clamps at this time.
7. Place another eyebolt in each weld on tab and thread on a 1/2” locknut a
short way.
8. Thread the end of each truss cable through the appropriate eyebolt and pull
the cable snug. Double-back the cable and secure in place with two 3/8”
cable clamps as in Step 2.
Figure 3.16