Manual

3. ASSEMBLY WHEATHEART - POST POUNDER

3.2. ASSEMBLING THE S2000 POST POUNDER S2000 MODEL

22 IM15 R1

3.2. ASSEMBLING THE S2000 POST POUNDER

Important: Always have two or more people assembling the equipment. Due to the weight of

the components, do not attempt assembly alone.

Important: Lock bars prevent front-back tilt and limit side-to-side tilt of the pounder mast

during transport and storage. Lock bars should also remain in place during

assembly.

To assemble the S2000 Post Pounder, perform the following procedures in the

order that they are listed:

• “Prepare the Frame Assembly” on page 22

• “Connect the Mast Assembly to the Frame Assembly” on page 23

• “Connect the Hugger Arm and Cylinder to The Mast Assembly” on page 25

• “Install Hammer Ballast” on page 26

3.2.1. PREPARE THE FRAME ASSEMBLY

1. Temporarily support the frame assembly under the frame near the jack stand

locations.

Figure 3.1 Preparing the Frame Assembly

WARNING

Do not attempt assembly without a lifting

device. Components are heavy and present a

crushing hazard which can cause serious

injury or death.

INSERT LOCK PIN

(TEMPORARY SUPPORT)