Owner's manual

WHEATHEART - PORTABLE DRIVE OVER PIT 7. MAINTENANCE
10" & 13" 7.1. FLUIDS & LUBRICANTS
30686 R0 35
7.3. MAINTENANCE PROCEDURES
7.3.1. VISUAL INSPECTION
When inspecting:
• Ensure all guards are in place, and in good working order.
• Examine the auger for damage or unusual wear.
• Inspect the machine for evidence of oil leaks.
• Examine hydraulic hoses and fittings for leaks and cracks.
• Be sure all safety decals are in place and are legible.
• Examine all flighting for damage or unusual wear.
• Examine tires for gashes, uneven wear, or loss of air pressure.
• Inspect auger shaft bushing for unusual wear or discoloration.
Figure 7.1 Bushing
7.3.2. SERVICING DRIVE CHAINS
1. Remove drive-over plates from the front of the portable pit. Check chain
slack.
• Chain slack is checked at the midpoint of the longest span. It should be
approximately 3/8” (10 mm). Do not over-tighten chain as it can deflect
augers. Refer to Figure 7.2.
BUSHING