Instruction Manual

3. ASSEMBLY WHEATHEART - GRAIN AUGER EMD
3.12. MOTOR / MOTOR MOUNT GHR 80 X 31’-71’ & 100 X 31’-71’
34 30642 R0
MODEL K1051 & K1550
See Figure 3.26.
1. Slide handle over flat sides of
input shaft.
2. Fasten with 1/2” locknut.
Do not remove or loosen the double
locknut on the input shaft: it is an
important part of the brake system of
the winch.
MODEL K2550
See Figure 3.27.
1. Slide handle over flat sides of
input shaft.
2. Fasten with 1/2” locknut.
Do not remove or loosen the locknut
on brake side of winch: it is an
important part of the brake system
of the winch.
3.12. MOTOR / MOTOR MOUNT
See Figure 3.28 and 3.29.
1. Attach electric motor mount to
gearbox with bolts and lockwashers
(Figure 3.28).
The 8” x 31’ auger requires the motor
mount to be positioned toward the intake
end of the gearbox.
2. Secure the tube clamp and motor
mount supports with 7/16” x 1" bolts
and locknuts.
3. Attach pulley guard bracket to motor
mount with two 7/16” x 1" bolts and
locknuts.
Figure 3.26
Important:
Figure 3.27
Important:
Figure 3.28
¨