User guide

CONNECTING YOUR LOUDSPEAKERS - 1

TERMINAL PANELS

All the loudspeakers connect to the amplifier via a twin

terminal connecting panel. The CR30.1 has a keyhole

mountintegratedinto the crossover panel.

Thepositive(+)terminal is located at the right of thepanel

andiscoded Red.TheNegative(–) terminal is coded Black.

CABLE PREPARATION

CONNECTING A SPEAKER TERMINAL

Prepare a length of loudspeaker cable for each speaker.

Splitthecores to a depth of about40mm.Carefullystrip the

insulation from each end, leaving about8mm of bare wire.

If the cable is stranded, lightly twist to gather any loose

strands.

Audio cable is polarised, with two cores of different colours,

or often a coloured tracer or identification rib. We suggest

that you connect the coloured/striped wire to the RED,

Positive terminals of your amplifier. This will ensure that

all the loudspeakers are connected the correct way round

andavoid set-up problems.

Unscrew a terminal. Thread the bared end of each cable

through the hole in the bottomof the terminal post. Ensure

that there are no loose strands which may touch adjacent

terminals.Retightentheterminal securely.

40mm

8mm

CR-30.1