User Manual 54inch Fireplace Console

ManualsBrandsWhalen ManualsElectric Fireplaces54-in W Madison Snow Ash Infrared Quartz Electric Fireplace

ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS

15. Attach one handle (JJ) to the front side of each door (N and O)

with the provided handle bolts (KK).

17a. Pick up left door (N) and attach the extended hinge arms to the

hinge bases installed on the left side frame (D). Loosen the bolt on

the back of the hinge base for an easy t. Align and insert the “U”

slot on the hinge arm under the bolt head on the back of the hinge

base.

Make sure that both door hinges engage and function properly.

Tighten the bolt on the hinge base to lock the hinges in place.

17b.

Repeat the same procedure to attach the right door (O) at the

opposite

side.

17c. Open and close the doors to make sure they are aligned and shut

correctly. If necessary, adjust the screws for a good t. Refer to the

hinge sticker on the door for adjustment.

17d. Stick the rubber bumpers (RR) at the outer corners of both doors

(N and O) where they meet with the partition panels (F and G).

Hardware Used

Rubber Bumper

Washer Head Screw x 32

Cam Lock Cover x 18

Shelf Pin x 8

Handle x 2

x 2

Handle Bolt x 4

x 4

1110

Follow these steps if you want to change your replace door

panels from wood (S) to glass (P). Otherwise, skip to Step 17.

16A. Take the left door (N) and loosen the screws on the inside of

the door frame.

16B. Rotate the clips to remove the old panel.

16C. Insert the new panel, then rotate the clips and tighten the

screws to secure the panel in the door frame.

16D. Repeat this process with right door (O).

18. Lift the replace insert carefully into the back of the assembled

mantel and center it in the opening. DO NOT drag the insert

across the bottom panel (B) as it may scratch the unit.

Electric

Firebox

Installing the replace insert

14a. Carefully stand the unit upright.

14b. Insert four shelf pins (II) into the desired holes inside

each side compartment. Make sure you place the 4 shelf

pins in the same level so the shelf is not tilted. Tilt and

rest the adjustable shelves (M) onto the shelf pins (II).

14c. Plug the cam lock covers (HH) onto the visible cams

locks (AA) to conceal the cams.

13a. Pick up the upper back panel (Q) and align the drilled holes

with the pilot holes on the back of the top panel (A). Attach

the upper back panel (Q) in place with the provided washer

head screws (EE).

13b. Align and attach two lower back panels (R) to the side

frames (D and E) and lower partition panels (F and G) with

the provided washer head screws (EE), using the plots holes

as a guide.