Technical Specifications

ManualsBrandsWhalen ManualsElectric Fireplaces60" Farmstead Electric Fireplace Entertainment Center in Laminate Aged Oak

Operation (continued)

Using the heater control

□

The heater button (4) turn

s the heater on or off. There is no speed setting for the heater blower.

If you put the heater in a standby mode

(turn off by the main power button 6), the unit will hold the settings in the memory. When the power is turned back on, the heater will

turn on at the same settings.

□

When the heating function turns on, press and hold the heater button (4) for five seconds to enter temperature adjustment mode. The

LED indicator is red. In adjustment mode, the display unit (1) flashes (interval is 0.5 second). There are 22 levels to change Fahrenheit

temperature 72°F―73°F…82°F ―ON—62°F ―63°F …71°F. After this is set, the display (1) will flash five times and exit from setting

status. If idle, the display turns off after 10 seconds.

□

With the heater on, gently press and hold the main power button for five seconds to enter temperature converting mode. The LED

indicator flashes five times in red color then changes to green. In this converting mode, the display (1) flashes (interval is 0.5 second).

Press and hold the heater button (4) for five seconds to enter temperature adjustment mode. There are 12 levels to change Celsius

temperature 22°C―23°C …27°C ―ON ―17°C ―18…21°C. After it is set, the display (1) flashes five times. If idle, the display turns off

after 10 seconds. Repeat the same process to convert Celsius temperature into Fahrenheit temperature.

□

When the heating function turns on, the display unit (1) on the control panel shows “00” and flashes (interval is 0.5 second) indicates

that it is in Demo mode. To activate the heater, the rocker switch on the back of the heater need to be set to the “O” position.

Using the flame control

□

Press the flame button (5) to set the flames for different levels of flame height. These flame levels

are shown in the display (1). The

flame settings are as follows:

Button Press

Flame Level

Display Value

Fireplace Appearance

1st press

High

Flames Highest, Logs Glow Highest

2nd press

Medium

Flames Medium, Logs Glow Medium

3rd press

Low

Flames

Low, Logs Glow Low

th press

All Off

None

Flames Off, Logs Off

□

Regardless of the previous flame setting, when powered off by the main power button (6), the flames will come on in L3 mode (High)

when you turn the heater on.

□

When the heater function turns on, the flame level will cycle through the 3 different level settings continuously.