Use And Care Manual

7
Operation (continued)
6
Using the main power button
7
Using Demo mode
□
Press the power button (6) to turn the fireplace/heater unit
on and off. Press the power button (6) once to turn the
unit on. Press again to turn the unit off.
□
Press the switch at the back of the fireplace to set the heater
to Demo Mode. It will eliminate the ability for the heater to be
turned on when the rocker switch is set at “I” position. The
rocker switch is set at “O” position for shipping which is to
keep the heater turn on with pressing the heater button on
control panel.
Using the Remote Control
1
Installing the battery
For replacement batteries, use lithium
-
based CR2025 batteries.
□ Take out the battery bracket.
□ Insert the battery with the button side into the battery bracket, making sure the battery is firmly seated.
□ Press the battery bracket into the remote control, making sure it snaps into position.
□ Turn the remote over and aim it towards the fireplace/heater unit.
□ Press the power button on the upper right, and see if the flames on the fireplace/heater turn on or off.
□ If nothing appears to happen, check to make sure the battery is installed correctly, and try again.
OPEN
PUSH
OPEN
P
USH
1
2
CR2025
LITHIUM BATTERY
3V
OPEN
PUSH
OPEN
PUSH
6