Instructions

Stand alone test mode of the K8062
Velleman Kit
Legen Heirweg 33
9890 Gavere
Belgium
Connect connectors SK1 (+) and SK2 (-) by means of a 9V battery for the DMX stand-alone test mode.
Test button SW1 is used for the test mode
Operation
• The device must not be connected with your computer for the stand-alone test mode.
• Press the button briefly to activate the unit. The power LED lights and the unit starts sending DMX code "0" to all
512 DMX channels.
• Press the button to increase the code on all channels to '1', press again to change the code to '2', etc.
• The "DMX signal" LED flashes briefly when the test button is held for some time.
• The flashes become longer when the button is pressed several times.
• When the button has been pressed 256 times, the internal counter rolls back to 0 and the unit starts to send code
"0" again to all 512 DMX channels.
• If you use e.g. a dimmer as a testing device, you can see the increase in luminous intensity every time you press
the button.
• To turn off the power, simply hold the button for ± 3 seconds until the power LED extinguishes.
Please check
www.velleman.be
for more info.