Instructions

- 5 -
DO NOT BLI N DLY FOLLOW T H E ORDER OF T H E
COMPONENTS ONTO T H E TAPE. ALWAYS CH ECK T H EI R VALU E ON T H E PART S LI ST !
•
•
• Thin raisin-core solder. Do not use any ux or grease.
• A diagonal cutter to trim excess wires. To avoid injury when cutting excess leads, hold the lead so they cannot
y towards the eyes.
•
• Small blade and Phillips screwdrivers. A basic range is ne.
)
• Make sure the skill level matches your experience, to avoid disappointments.
•
•
•
•
• Use the check-boxes to mark your progress.
•
* Typographical inaccuracies excluded. Always look for possible last minute manual updates, indicated as ‘NOTE’ on a separate leaet.
Trim excess leads as close as possible to the solder joint.
฀฀฀฀฀฀฀฀฀฀฀฀฀฀฀฀฀฀฀฀฀฀฀ ฀฀฀฀฀฀฀฀฀฀฀฀฀฀฀฀฀฀฀฀฀