Manual

9
Construction
STEP 2: Thin the wires.
Step 4: Solder the cables on the PCB.
STEP 1: Strip both cables and twist the wire
ends of each cable.
STEP 3: Mount both cables as shown in the
drawing.
+
-
17 Mounting the test leads
Tip: Start with one cable and then do
the other.
18 Mounting the battery holder
STEP 1: Stick one part of the included hook-and-loop strap (hooks)
on one of the long sides of the battery holder.
STEP 2: Connect the battery holder to the base
PCB using the included red and black mounting
wires. Mind the polarity!
• Red = +
• Black = -