User Manual

Uploading the first sketch to the board

4. Once the ESP32 core has been installed, open the tools menu and select the ESP32 Dev module board by

going to: Tools > Board:"..." > ESP32 Arduino > ESP32 Dev Module

5. Connect the Whadda ESP32 module to your pc using a micro USB cable. Open the tools menu again and

check if a new serial port has been added to the port list and select it (Tools > Port:”…” > ). If this is not

the case, you may need to install a new driver to enable the ESP32 to properly connect to your

computer.

Go to https://www.silabs.com/developers/usb-to-uart-bridge-vcp-drivers to download and install the

driver. Reconnect the ESP32 and restart the Arduino IDE once he process has finished.