User Manual

12
5. Open the serial monitor ( ), and check that the baudrate is set to 115200 baud:
6. Press the Reset/EN button, debug messages should start appearing on the serial monitor, together with
status info about the network connection and the IP-address.
Take a note of the IP address:
Is the ESP32 having trouble to connect to your WiFi network?
Check that the WiFi network name and password have been set up correctly, and that the ESP32 is
in range of your WiFi access point. The ESP32 has a relatively small antenna so it might have more
difficulties to pick up the WiFi signal at a certain location than your PC.