Technical Manual

WH Münzprüfer Dietmar Trenner GmbH, Germany Technical Manual BLK 100
version 1.90
BLK 100 subject to technical modification page 7/11
5. BLK 100 Label
The label of the BLK 100 has all the necessary information required to
identify it. The following section explains and clarifies the format and
legend on the label.
Fig. 4 Example of an BLK 100 label
Below the firmware version the exact type of BLK 100 is printed. Below
the barcode is the serial number and the week and year of manufacture.
The same information is contained in the bar code. The next line indicates
the firmware version, that has been used when the device was
programmed in the factory.
The label must be clearly readable. Do not remove it. Do not tamper with
the details shown on it. Please remember that the guarantee is associated
with the series number and manufacturing code.
6. Accessories (Connection to Controller)
Cable to connect the Key fob reader BLK 100 to the machine’s controller
are not in the scope of delivery.
All machines are connected to the BLK 100 via the 10-pole connector on
the back of the device (pls. refer to figure 3).
Examples for connecting cables:
K 120 BLK 100 - ACA H7S Controller and Midas Controller
K 121 BLK 100 - Titanium Controller
K 122 BLK 100 - Centurion Controller