User's Manual

Q) How do I oil my marker?
A) 1.You only need to lubricate your marker after every 4 to 5 days of play. To oil
your maker you first, in a safe environment, remove your loader, then fire all excess
paintballs out of the marker. Next remove your tank and fire all excess air from the
marker. Now remove your barrel. Next drop 3 to 4 drops of either 3 in 1 oil or any other
approved paintball marker oil into the air receiver and safely fire the marker 10-15
times. This will distribute the oil throughout the internals of the marker. At this time
you can also lubricate your bolt 0-rings. Be sure that the hole in between the 2 O-rings
on your bolt is always facing down. Factory approved lubricants: Petroleum jelly and 3
in 1 oil..
Q) How do I safely clean my worrframe and eye?
A)To clean your worrframe you first find a safe environment then remove your loader,
then fire all excess paintballs out of the marker. Next remove your tank and fire all ex
-
cess air from the marker. Now remove your barrel, then lightly spray down marker with
a 50-50 mix of rubbing alcohol and water and then wipe it down with a clean cloth. If
there is any splatter or hits on the frame clean them up. Keep some q-tips around for
hard to get spots and if paint got inside the frame they come in handy.
Q) Does WGP recommend C02 or compressed air?
A) WGP recommends compressed air.
Q) Iʼve removed my bolt and replaced it, and my velocity has dropped. What is the
problem?
A) Any time your remove the bolt from your marker, you must always be sure that the
hole in between the 2 O-rings on your bolt is always facing down before reinstallation.
This is common problem that could directly effect the velocity of your marker.
VI. F.A.Q.
Wor r fr a m E Ma n u a l
Page 17