User's Manual

Make sure

bolt is installed

correctly.

V. Troubleshooting

Note: A qualified technician should make all repairs and adjustments.

Do not attempt to perform any factory-only repairs. Call WGP for

any service needed on your marker. Any damage caused by

improper adjustments is not covered by the warranty.

1. Marker will not fire properly after removing and replacing bolt.

• Bolt installed upside down. Remove bolt. Reinstall after rotating 180

degrees. The hole side should be facing down.

Wor r fr a m E Ma n u a l

Page 14

2. Marker will not ﬁre when trigger is pulled.

• Gas source pressure low or tank empty. Fill tank.

• Make sure the hole in your bolt, between the 2 o-rings is facing down.

. Battery is dead or low, replace with new battery