User's Manual

III. Cleaning Your Marker
WARNING: Always make sure you and everyone around you
wears face, eye and ear protection when you clean the marker or check it for
paintballs.
It isnʼt necessary to completely disassemble your marker to clean it. WGP
recommends the following cleaning be done after each day of play:
1. Before you start ALWAYS make sure that all paintballs are out of the marker.
2. Remove air source and ensure that all air has been released from the mark-
er.
3. Remove the barrel sock and then remove the barrel.
4. Lightly spray marker down with a 50-50 mix of rubbing alcohol and water
and then wipe down.
5. Wipe down the marker with a clean cloth, or blow off the marker with
compressed air (NOT CO
2
).
6. Remove bolt and lubricate bolt O-rings with petroleum jelly or lithium
grease, then reinstall.
7. Lubricate all moving parts with Vaseline, and reassemble.
8. WGP recommends that after every 4-5 days of play you place 3-4 drops
of 3 in 1 or other paintball marker specific oil in the air receiver and fire the
marker
10-15 times without the barrel. This will distribute the oil throughout
the marker and lubricate the internals.
Factory approved lubricants: • Petroleum Jelly
• Lithium Grease
Wor r fr a m E Ma n u a l
Page 12