Owner's Manual

WORR MACHINE® MARKER OWNERS MANUAL

IV. WORR MACHINE EG (ELECTRONIC) — E-GRIP OPERATION
1. Eye Protection: Ensure all individuals within 200 yards are properly protected against
paintball impacts.
2. Engage Safety & Install Barrel Sleeve: Push Safety from left to right on marker; Red Band
around the safety should not be showing if the safety is on. Properly Install Barrel Sleeve.
3. Install Battery: Remove three allen screws and remove right side grip cover and properly
install 9 volt battery.
4. Test for Power: To test for power press and hold down bottom button (below two lights
on back of grip) for approximately 2 seconds. 2 Green lights should be illuminated.
Reinstall grip cover (Do Not Over-Tighten Screws).
5. Switching Between Modes: Once the power is turned on, the marker will be in the initial
setting of Semi-Automatic Mode (setting 1). This setting will be indicated by the bottom
light turning Green. To switch to the 3 Round Burst Mode (setting 2) press the button once,
the bottom light should turn Amber. You should now be in 3-Round Burst Mode. To switch
to the Full-Auto Mode press the button once, the bottom light should turn Red. You should
now be Full-Auto Mode. To switch back to the initial Semi-Auto Mode (setting 1) press the
button once, the bottom light should turn Green. You should now be in the initial setting
of Semi-Auto Mode (setting 1).