User Manual

Autococker® trilogy Select-Fire MAnuAl

Make sure
bolt is installed
correctly.
VI. TROUbLESHOOTING
NOTE: A qualified technician should make all repairs and adjustments. Do not attempt
to perform any factory-only repairs. Call WGP for any service needed on your marker.
Any damage caused by improper adjustments is not covered by the warranty.
1. Marker will not fire if left in the sun or a hot place with tank attached.
• Bottle pressure exceeds 1100 psi. and wont allow exhaust valve to open. Make sure
you are in a safe environment then remove tank from marker be sure to point marker
at the ground and fire the excess air out of the marker. Place marker and air tank
in a cool, safe place.
2. Marker will not fire properly after removing and replacing bolt.
• Bolt installed upside down. Remove bolt. Reinstall after rotating 180 degrees.
The hole side should be facing down.