User Manual

Autococker® trilogy Select-Fire MAnuAl



II. PREPARING fOR USAGE

• Paintball industry approved protective gear (for face and eyes) must be worn

at all times while operating and performing adjustments on this marker.

• Do not insert objects into the space between the cocking block and the main

body of the marker at any point in time. Improper marker treatment may result

in damage to the marker and serious injury to the operator.

• Prior to beginning any work on your marker, check to make sure that all excess

pressure has been released by pointing the marker in a safe direction and pulling

the trigger. This is a necessary precaution due to the fact that the marker may

still contain pressure even after the removal of the gas source.

• Damages to the marker due to improper adjustments are NOT covered under

warranty. If you are uncertain, unable or do not know how to perform work on

the marker, have adjustments and repairs made by WGP.

Turning On and Off the Electronics:

To turn on the marker, press and hold the button until the led lights up. For semi mode, the marker

will ﬂash green quickly. To turn the eye system off — press and hold the button; the LED will turn solid

yellow. Release the button — the eye system has now been turned off. When the eye system is off the

LED will ﬂash slowly. To turn the marker off, press and hold the button until the LED goes solid yellow

then solid red and release.

III. VELOCITY

WARNING:

WGP does not set the velocity prior to leaving the factory. You MUST set the velocity within field and

safety limits using a chronograph prior to playing. Always use a chronograph to verify that your mark-

ers velocity does not exceed maximum safety limits.