Autococker® Marker Manual
Autococker® Trilogy Select-Fire Manual WORR GAME PRODUCTS, LLC. TRILOGY® AUTOCOCKER® OWNERS MANUAL WARNING: This Always is not wear a toy. paintball Misuseapproved may cause eye serious and face injury protection or death.when Eye protection dealing with designed a pressurized specifipaintball cally for paintball marker. must be worn by the user and persons within range. Recommend 18 years or older to purchase.
Autococker® Trilogy Select-Fire Manual W ’elcome to the world of Autocockers, and thank you for your purchase of a new Autococker® marker. You will now be able to experience paintball at its highest level. Table of Contents I. Rules of Safe Paintball Marker Handling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xx II. Preparing for Use. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Autococker® Trilogy Select-Fire Manual I. R ules of S afe Paintball M arker H andling. Your A utococker®marker is not a toy. 18 years old to purchase. 14 years old to play with adult supervision or 10 years old to use on paintball fields meeting ASTM-standard F1777-97. Respect other peoples’ property and when using the Autococker® marker, obey all local, state and federal laws. When entering a paintball field, become aware of their rules and regulations.
Autococker® Trilogy Select-Fire Manual I. R ules of S afe Paintball M arker H andling. • Treat every marker as if it were loaded. • Never look down the barrel of a paintball marker. • Keep your finger off the trigger until ready to shoot. • Never shoot a person not wearing proper protection. • Never point the marker at anything you don’t wish to shoot, even if it is not loaded and there is no air source attached. • Keep the marker on safe until ready to shoot.
Autococker® Trilogy Select-Fire Manual II. P reparing for Usage 1. Screw barrel onto marker 2. Place barrel blocking device properly onto the marker 3. Pull the cocking rod back until it latches into place 4. Make sure the safety is pushed to the “PUSH SAFE” position. 5. Connect the tank to the ASA (air system adapter.) NOTE: Make sure to always get your cylinders filled by authorized, skilled and knowledgeable technicians for the correct fill limits of each cylinder.
Autococker® Trilogy Select-Fire Manual M arker Schematic BARREL FEED TUBE PULL PIN BOLT COCKING ROD BEAVER TAIL INLINE REGULATOR TRIGGER SAFETY PUSH FIRE PUSH SAFE ASA (AIR RECEIVER) If you experience a problem with your Trilogy, please contact WGP for service. DO NOT RETURN TO PLACE OF PURCHASE.
Autococker® Trilogy Select-Fire Manual II. P reparing for Usage Sequence Of Operations: When you pull the trigger, it activates a micro switch which tells the processor on the board to activate the internal electronic valve. This valve fills the ram inside the grip frame. The ram lowers the sear, which releases the hammer. The hammer strikes the valve, which allows gas to flow through the bolt and down the barrel, propelling a ball out.
Autococker® Trilogy Select-Fire Manual II. P reparing for Usage • Paintball industry approved protective gear (for face and eyes) must be worn at all times while operating and performing adjustments on this marker. • Do not insert objects into the space between the cocking block and the main body of the marker at any point in time. Improper marker treatment may result in damage to the marker and serious injury to the operator.
Autococker® Trilogy Select-Fire Manual III. Velocity To Adjust Velocity: 1. Remove the cocking rod by unscrewing it counterclockwise. 2. Insert the provided 3/16” Allen wrench in place of the cocking rod so that it passes through the IVG (Internal Velocity Governor). Turning the Allen wrench clockwise will increase the velocity while counterclockwise will decrease the velocity. 3. Movement of the wrench quarter turn in either direction will change your velocity approximately 15-20 fps (feet per second).
Autococker® Trilogy Select-Fire Manual IV. C leaning Your M arker It isn’t necessary to completely disassemble your marker to clean it. WGP recommends the following cleaning be done after each day of play: 1. Before you start ALWAYS make sure that all paintballs are out of the marker. 2. Remove air source and ensure that all air has been released from the marker. 3. Remove the barrel sock and then remove the barrel. 4.
Autococker® Trilogy Select-Fire Manual V.
Autococker® Trilogy Select-Fire Manual VI. T roubleshooting Note: A qualified technician should make all repairs and adjustments. Do not attempt to perform any factory-only repairs. Call WGP for any service needed on your marker. Any damage caused by improper adjustments is not covered by the warranty. 1. Marker will not fire if left in the sun or a hot place with tank attached. •B ottle pressure exceeds 1100 psi. and wont allow exhaust valve to open.
Autococker® Trilogy Select-Fire Manual VI. T roubleshooting 3. Marker will not fire when trigger is pulled. • Gas source pressure low or tank empty. Fill tank. • Make sure the hole in your bolt, between the 2 o-rings is facing down. • Make sure battery is installed, and has a good charge. 4. Marker will not cock or cocks every other time or less. • Pressure too low. Fill tank. • Velocity adjustment set too high. • Back block or cocking rod adjustment incorrect.
Autococker® Trilogy Select-Fire Manual VI. T roubleshooting 5. Chops paintballs. • Make sure your cocking rod is screwed all the way in. • Paint is soft or swelled. Ensure that paint is not too large for barrel. • Check loader and breech for foreign matter. 6. Hose blows off. • Clip off worn tip and reinstall or call WGP for service 800-755-5061. 7. Leaking between tank valve and marker air-receiver. • Bad tank valve o-ring. Replace o-ring.
Autococker® Trilogy Select-Fire Manual VI. T roubleshooting 10. Marker fires and block comes back but wont go completely forward; locks approximately halfway. •R emove bolt and lubricate o-rings. Reinstall bolt making sure the hole between the 2 o-rings is facing down. • Paintball shell caught between bolt and body at feed tube. Ball detent screwed in too tight.
Autococker® Trilogy Select-Fire Manual VII. F.A.Q. Q) How do I safely maintain my WGP Autococker® marker? A) Safely maintaining your marker is simple and easy. You need only clean and oil your marker to keep it up and running. Q) How do I oil my marker? A) You only need to lubricate your marker after every 4 to 5 days of play. To oil your maker you first, in a safe environment, remove your loader, then fire all excess paintballs out of the marker.
Autococker® Trilogy Select-Fire Manual VII. F.A.Q. Q) What kind of eyes are in my marker? A) Your marker uses a “break beam” style eye system. How this works is there is an eye on each side that projects an invisibile beam from side to side. When this beam is broken by a paintball, the eyes tell the board Q) Sometimes when I air up my marker, I hear air coming out of the barrel.
Autococker® Trilogy Select-Fire Manual VII. F.A.Q. Q) I’ve removed my bolt and replaced it, and my velocity has dropped. What is the problem? A) Any time your remove the bolt from your marker, you must always be sure that the hole in between the 2 O-rings on your bolt is always facing down before reinstallation. This is common problem that could directly effect the velocity of your marker.
Autococker® Trilogy Select-Fire Manual VIII. One Y ear L imited Warranty Worr Game Products®, LLC. warrants that your Autococker® marker will be free from defects in materials and workmanship for one year from purchase date. Any product determined by WGP to be defective in materials or workmanship in accordance with the above warranty will be repaired or replaced, at the option of WGP, free of charge when received at the factory freight prepaid, together with proof of purchase.
P lease fill out Warranty C ard on other side and mail in to Worr G ame P roducts with your R eciept R ereceipt.
Attention Warranty S ervice Worr Game Products LLC. Warranty Registration Card Please fill out this warranty card and mail with a photocopy of your purchase receipt to WGP. Thank You.
® Worr G ame P roducts LLC. 252 Granite Street Corona, CA 92879 U.S.A. Phone: 909.520.9969 Fax: 909.520.9699 www.worr.
