User's Manual

Note: Your 04 Autococker

comes with an adjustable front regulator. This

regulator controls the cocking pressure that flows through the 3-way

and ram. Adjustment should be done in quarter turn increments. This

regulator does not control the velocity of your paintball marker. Under

no circumstances should you disassemble the regulator.

VII. Cleaning Your Marker

CAUTION: Always make sure you and everyone around you wears pro-

tection when you clean the marker or check it for paintballs.

It isnʼt necessary to completely disassemble your marker to clean it. WGP

recommends the following cleaning be done after each day of play:

1. Remove air source and ensure that all air has been released from the marker.

2. Remove the barrel.

3. Lightly spray marker down with a 50-50 mix of rubbing alcohol and water

and then wipe down.

4. Wipe down the marker with a clean cloth, or blow off the marker with

compressed air (NOT CO

5. Remove bolt and lubricate bolt O-rings with petroleum jelly or lithium grease,

then reinstall. If you have a Delron bolt, do not lubricate.

6. Lubricate the threads and all moving parts with Vaseline, and reassemble.

7. WGP recommends that after every 4-5 days of play you place 3-4 drops

of 3 in 1 or other paintball marker specific oil in the air receiver and fire the

marker 10-15 times without the barrel. This will distribute the oil throughout

the marker and lubricate the internals.

Factory approved lubricants: • Petroleum Jelly

• Lithium Grease

• 3 in 1 Oil

Au to co c k e r

M ar ke r Ma n ua l

Page 10