User's Manual

V. Velocity
• Paintball industry approved protective gear (for face and eyes) must be worn at
all times while operating and performing adjustments on this marker.
• Do not insert objects into the space between the cocking block and the main
body of the marker at any point in time. Improper marker treatment may result
in damage to the marker and serious injury to the operator.
• Prior to beginning any work on your marker, check to make sure that all excess
pressure has been released by pointing the marker in a safe direction and
pulling the trigger. This is a necessary precaution due to the fact that the
marker may still contain pressure even after the removal of the gas source.
• Damages to the marker due to improper adjustments are NOT covered under
warranty. If you are uncertain, unable or do not know how to perform work on
the marker, have adjustments and repairs made by a qualified technician.
CAUTION: WGP does not set the velocity prior to leaving the factory. You
MUST set the velocity within field and safety limits using a chrono-
graph prior to playing. Always use a chronograph to verify that
your markerʼs velocity does not exceed maximum safety limits.
To adjust Velocity:
1. Remove the cocking rod by unscrewing it counterclockwise.
2. Insert the provided 3/16” Allen wrench in place of the cocking rod so that
it passes through the IVG. Turning the Allen wrench clockwise will
increase the velocity while counterclockwise will decrease velocity.
3. Movement of the wrench quarter turn in either direction will approximately
yield a 15-20 fps. change.
+
-
3/16” Allen Wrench
Back View
DO NOT
EXCEED 300 FPS!
IVG should not
be deeper than 1/4”-
1/2” inside of receiver
Au to co c k e r
®
M ar ke r Ma n ua l
Page 8