User's Manual

VII. Troubleshooting
Note: A qualified technician should make all repairs and adjustments.
Do not attempt to perform any factory-only repairs. Send the
marker to the factory or an authorized repair center. Any damage
caused by improper adjustments is not covered by the warranty.
Call Worr Game Products for further information.
1. Marker will not fire after left in the sun or a hot place with bottle attached.
• Bottle pressure exceeds 1100 psi. and wont allow exhaust valve to open.
Remove bottle from marker to allow excess CO
2
to escape. Remove
marker and tank from sun and allow to cool.
2. Marker wont fire properly after removing and replacing bolt.
• Bolt installed upside down. Remove bolt. Reinstall after rotating 180
degrees. The hole side should be facing down.
13
Make sure
bolt is installed
correctly.
ON OFF
SAFETY