User's Manual

PAGE 7
INSTALLATION ONTO D10 &
IR10 CAMERAs
2
With the YN1 Wi Module facing backwards, as
illustrated below, place it onto the top of the
camera so that the USB prong ts into the USB
insert. (Illustration F) Note: Do not force the USB
plug into port.
3
Screw the stabilizer screws on either side of the
YN1 module into the camera. (Illustration G)
Note: If you unstall the YN1 module, you must
replace the USB port protective cap, or damage
to the camera will occur. This damage will not
be covered by warranty.
Note: To insure that the YN1 module is installed
correctly, power on the camera. Then power on
the YN1 module with remote. Make sure the LED
on the YN1 module is on.
(Illustration G)
(Illustration F)