User's Manual

Ready
Time/Date
Location
Trigger
Flextime
PIR Mode
PIR Active
Delay
PIR Mode Flextime Both
P1 P2 Interval
Still Video
24Hr Day Night
30sec 1min 2min 5min
Ready
Time/Date
Location
Trigger
Flextime
PIR Mode
PIR Active
Delay
PIR Mode Flextime Both
P1 P2 Interval
Still Video
24Hr Day Night
30sec 1min 2min 5min
Power Save
Power On
Setting Time
Test Mode
1.
Check the battery level icon to
ensure the batteries just
installed contain the proper
charge level. If so, you are ok to
proceed with camera use.
2.
To turn the unit ON, press and
release the power button.
1.
To change date and time, start by
pressing and release the center
navigation button to set the hour.
2.
Press the left or right navigation
button to go up or down in
sequence.
3.
When the hour is set, repeat steps
1 and 2 to set the minutes.
page 5
page 6
NOTE: LCD cycle through camera
information. PIR picture number >
Flextime number > Remaining
pictures > Time
After 30 seconds without any
buttons being pushed, the LCD
will turn off and camera enters
into Power Save or Ready Mode.
1.
The LCD screen can be awak-
ened by pressing the Power
button briefly.
Note: The LCD will not “wake up” when
camera is writing to memory.
2.
PIR LED Status Light: During the
first 2 minutes of Ready Mode,
the red light will illuminate when
a PIR event is triggered. The red
light will blink for 2-3 seconds
when photo is taken during this
first 2 minutes. After 2 minutes
all indicator lights will turn off
until a button is pressed.
1.
LCD Ready Mode: The camera
will automatically enter Ready
Mode if a button is not pressed
for greater than 30 seconds. The
status lights will illuminate for a
total of 2 minutes.
2.
Ready
Time/Date
Location
Trigger
Flextime
PIR Mode
PIR Active
Delay
PIR Mode Flextime Both
P1 P2 Interval
Still Video
24Hr Day Night
30sec 1min 2min 5min
POWER
POWER
Ready
Time/Date
Location
Trigger
Flextime
PIR Mode
PIR Active
Delay
PIR Mode Flextime Both
P1 P2 Interval
Still Video
24Hr Day Night
30sec 1min 2min 5min
Ready
Time/Date
Location
Trigger
Flextime
PIR Mode
PIR Active
Delay
PIR Mode Flextime Both
P1 P2 Interval
Still Video
24Hr Day Night
30sec 1min 2min 5min
POWER
Ready
Time/Date
Location
Trigger
Flextime
PIR Mode
PIR Active
Delay
PIR Mode Flextime Both
P1 P2 Interval
Still Video
24Hr Day Night
30sec 1min 2min 5min