Installation Guide

2022-Frameless Single cabinet Installation Instructions Page 5 of 5

The door is warped: Solid wood doors do occasionally warp due to the final

drying of the wood. There is a simple test you can perform to ensure that your

door is not warped. Remove the hinges by taking out the four screws holding

them in. The hinges will then just pull out (though they do fit in the holes

tightly). Now lay the door down face up on a flat surface such as a table or

counter. If the door can rock from corner to corner, it may be warped. 98% of

doors will lay perfectly flat. Push down on each corner. If the door rocks, check

to see how much it is coming up off the counter. Anything more than 1/8” is a

warped door. Anything less than 1/8” is within tolerances and is NOT warped.

Hinge manufacturing defects: All Blum hinges are manufactured to the highest

quality standard, and are the leader in the industry. However, occasionally we

have run across a hinge that something just wasn’t quite right on it. In these

instances, replacing the hinge took care of the problem. It is extremely rare to

have a defective hinge, but it can happen. If nothing else solves the problem, the

hinges could be at fault. Please call us for a replacement hinge.

Still have questions or need help?

Installation videos are on our website:

WGWoodProducts.com

Enter the link into your browser:

https://www.wgwoodproducts.com/store/agora.cgi?cartlink=Installation_Videos.htm

Or you can call us at 913-829-6000, enter 2 for installation help/assistance.