User Manual

WiFi Floor Guard & Door Guard EAS Systems
7
PRE-INSTALLATION INFORMATION
Quick Start for System Connections
A Floor Guard system consists of a smart power supply (WG SPS-24), WiFi Control Unit,
Floor Antenna and Adapter box. A Door Guard system consists of a smart power supply (WG
SPS-24), WiFi Control Unit, Door Guard and Adaptor Box. Connection between the various
modules is identical.
The smart power supply has a 6-pin output connector for the 24vac output to power the WiFi
Controller and also communicate with the control unit for tuning control and remote alarm
display features.
The WiFi Control Box is powered and controlled by the WG SPS-24 power supply unit. Also
the control unit has two 4-conductor connectors for cables that will connect to the WIFI
Control Unit AM board. One of the connectors is 4-pin connector for TX transmitting signals
from the Control Unit to drive a loop antenna coil. The other connector is a 4-pins connector
for RX signals from the Control Unit to receive signals from Floor Guard RX antennas.
Note: Both the TX and RX cables are color coded and it is critical not to transpose the
order.