User's Manual

9
Deactivator Components and Connections
As shown in Figure 1, the deactivator consists of a detect/deactivator antenna
pad, power and control box. The cables used and connections are shown in
the following diagram. The antenna pad can be installed flush to the counter
with the flush mount kit.
AN1
AN2
AC INPUT
POWER
O
I
AN2-HIGH VOLTAGE !
CARE IN OPERATION
7-pin Connector
4-pin Connector
Power Plug
Always match the antenna type (read the label on
the plastic housing) with control box input voltage
type before connecting them; make sure they are
matched.
An 110VAC antenna cannot be connected to a
220VAC control box, nor vice versa.
The StealthPad and FastPad control boxes may
look identical but their designs are different and
cannot be interchanged. Please read the label on
the control box to avoid using the wrong one.
Antenna
Control Box
A
n 1
A
n 2
HIGH VOLTAGE – HANDLE WITH CARE!
Equipment must be electrically disconnected from
the branch-circuit supply when connecting the
antenna with the control box.