User's Manual

6
Flush Mount Cut Out Suggestion
Installation Site Power Supply Check
IT’S RECOMMENDED TO HAVE ALL STEALTHPADS ON THE SAME
POWER PHASE
，
otherwise you need to adjust B sync value step by step
to find a best position to sync different StealthPads connected to power
source with difference phase.
IT’S RECOMMENDED HAVING ENOUGH CURRENT SUPPLY FOR
STEALTHPADS IF THERE ARE MULTIPLE STEALTHPADS SHARING
ONE POWER SUPPLY. The rated current for StealthPad is 5A but the
suggested current draw for one StealthPad is 7-8A for better performance,
so a 15A power box will better serve 2 StealthPads instead of 3 or more.
IT’S RECOMMENDED HAVING GOOD GROUNDING FOR POWER
SUPPLY OF STEALTHPAD. (Some time the poor grounding and high
noise from power supply will decrease the sensitivity or detection range,
check Noise entry D1 and D2, a value over 6-7 will be considered as big
noise)
185mm
(7.3”)
203mm
(
8.0”
)
Cut
86.6mm 3.4”
Cable Outlet
3cm free space around
pad for ventilation.
Antenna pad to control box
1.8m, 6 ft
Control box to AC
1.8m, 6 ft
Flange:
220.0x235.0mm
8.7”x 9.3”