User's Manual

Premier Pro Installation Manual
23
Tuning Procedures & Tips
There are mainly two problems that affect system’s functioning and
performance. One is that system picks up tags and labels poorly. The other is
that system false alarms (or causes other system to do so) without tags or
labels in detection zone.

Low Pick up Rate
1. Check noise “D” (ranging from 0-
999, >100 or so is big noise & >400
is heavy noise).
2. Adjust MIN, GN & RE to increase
sensitivity (see diagram below).
3. Adjust POT for Rx signal pre-
process sensitivity on TX board (see
page 12).
4. Shorten pedestal separation or use
stronger tags (e.g. Super Pencil).

Interference with or by other
systems
1. Swap L & N terminals on power plug
of control pack.
2. Adjust SYN “B” step by step to align
up with other systems.
Please open and tune the systems one by one if there are multiple systems
installed. It will help determine which system is causing the problem.
PROBLEMS
SOLUTIONS
The diagram below explains how the major three tuning parameters influence
system performance.
200
RE
Default 8
GN
MIN
Default 40
Increase Sensitivity
But Tendency to
False Alarm
Decrease Sensitivity
Shorter detection range
But prone to stability
0
14
0
GN
POT
Clock wise
Counter Clock wise