User's Manual

9
Deactivator Components and Connections
As shown in Figure 1, the deactivator consists of a detect/deactivator antenna
pad, power and control box. The cables used and connections are shown in
the following diagram. The antenna pad can be installed flush to the counter
with the flush mount kit.
Antenna
Control Box
7-pin
Connector
4-pin
Connector
Power Plug
Always match the antenna type (see page
3) with control box internal jumper setups
before connecting them; make sure they
are matched.
The control box hardware is identical to all
antennas but their internal jumper setups
are different and cannot be mixed.
HIGH VOLTAGE – HANDLE WITH
CARE!
Equipment must be electrically
disconnected from the branch-circuit
supply when connecting the antenna
with the control box.