User's Manual

21
Under this mode, you can also see the different noise condition at a different
phase. If there is a phase problem, other AM systems’ burst transmission will
interfere with FastPad’s receiver, and you will see a large noise indication in
D1, D2.
Key ID “D” - Noise Condition Display
(Valid parameters: 1,2,3,4 - see configuration table below)
The LEDs display the signal level number, with a level range from 0-8.
Note: When in the noise condition display mode, the alarm will be deactivated
until you exit this mode.
Press [NSE] and the LEDs will display as shown below.
Input a number for the parameter.
Press [CON] to accept the parameter.
LAN
REMOTE CONTROL
7 -
LAN
REMOTE CONTROL
0 d