User's Manual

14
Recorded Media Products Deactivation
Instructions:
1. Access to Programming Mode
• Press [PSW]
• Input password (default is 68 unless previously changed).
• Press [CON] to enter programming mode.
2. Set TX OFF to enable low power deactivation mode
• Press [Tx OFF]
• Input 1 to enable low power deactivation.
•
Press [CON] to accept the parameter.
3. Save to control box Flash ROM
• Press [SA]
• Input 1.
•
Press [CON] to accept the parameter.
• Press [EX] to exit programming mode.
Low Power Deactivation is strongly recommended fo
r
magnetic media products such as pre-recorded audio
tapes, video tapes, floppy disks, etc. Use the remote
control to set FastPad to low power deactivation mode.
Deactivation Range Change!
When setting FastPad to low power deactivation mode fo
r
media products deactivation, the active distance fo
r
deactivation is shortened accordingly. You must now place
the label closer to deactivation antenna surface to ensure
complete deactivation.
DR labels
Vertical Detection 4cm (1.5 in)
Horizontal 2cm (1 in)