User's Manual

7
Installation Site Power Supply Check
IT’S RECOMMENDED TO HAVE ALL FASTPADS ON THE SAME
POWER PHASE
，
otherwise you need to adjust B sync value step by step
to find a best position to sync different FastPads connected to power
source with difference phase.
IT’S RECOMMENDED TO HAVE ENOUGH CURRENT SUPPLY FOR
FASTPADS IF THERE ARE MULTIPLE FASTPADS SHARE ONE
POWER SUPPLY. The rated current for FastPad is 5A but the suggested
current draw for one FastPad is 7-8A for better performance, so a 15 amp
power box will better serve 2 FastPads instead of 3 or more.
IT’S RECOMMENDED TO HAVE GOOD GROUNDING FOR POWER
SUPPLY OF FASTPAD. (Some time the poor grounding and high noise
from power supply will decrease the sensitivity or detection range, check
Noise entry D1 and D2, a value over 6-7 will be considered as big noise)