User's Manual

Fuse Replacement Information
The fuse holder is located on the control box inside Socket PC board.
WARNING – TO REDUCE THE RISK OF DAMAGE; REPLACE ONLY WITH
THE SAME FUSE TYPE AND RATING.
1. Equipment shall be electrically
disconnected from the branch-
circuit supply when replacing the
fuse.
2. Remove the fuse holder with a
screwdriver, rotating it in a
counterclockwise direction.
3. Replace the fuse in accordance
with the specification noted
below.
Fuse Replacement:
Extended Fuse (Time-Delay Fuse)
5mm x 20mm 24vac @ T3.15A/250V