User's Manual

Pro-Guard & Uni-Guard Installation Manual
22
Remote Control Programming
Without receiving remote control signals, the panel displays the alarm count, indicating the
number of times the system has alarmed. See Figure 1.
Figure 1. Alarm Count
Press [PSW] button to open the remote control, then enter the password. The default
password, if not previously changed, is 689.
Figure 2. Display after [PSW] is Pressed
Input Password 689 and press [CON] to confirm/accept the password.
Note: Inputting the wrong password will cause an error message to be displayed as
per the following picture. After three successive times of inputting an incorrect
password, the remote will be disabled. You will need to turn system power off/on and
input the password again.