User's Manual

Pro-Guard & Uni-Guard Installation Manual

On Pro-Guard systems there is an interconnection between the receiver and transmitter.

Connect the Interconnection Line Plug onto socket J3 (6-pin connector) on the PC Board as

shown in the picture below (both transmitter and receiver, circled in red).

Pro-Guard Receiver – Bottom PCB

Pro-Guard Transmitter – Bottom PCB

Note: If this is a Pro-Guard installation using two Transmitters & one Receiver, use J3

and J12 to connect the two transmitters. Do not use the J1 (Rx Slave) port.

6-Pin Interconnection

Connector

Screw Torque

Specifications

1.7Kg/cm