User's Manual

Pro-Guard & Uni-Guard Installation Manual
14
Pro-Guard Receiver – Bottom View
There is one external alarm switch J8 on the Pro-Guard receiver and Uni-Guard. The switch
is closed only when an alarm is triggered by the system. To connect the system to an external
alarm, first press down the yellow button, then insert the two ends of the external alarm wire
into each of the wire receptacle holes and release the yellow button. The wire will now be held
in place by the connector. The external alarm switch has a rating of 1A@250vac/24vdc.
Battery or Power
<1A@24vdc
J8
Alarm
Pro-Guard Receiver Bottom PCB
Notes:
1. Wire length to the dry contact circuit is limited to 20 feet.
2. To prevent high voltage noise from being introduced into
the Pro-Guard or Uni-Guard and degrading the system’s
performance, it is highly recommended that you use a
24vdc output relay.